

4īurke Centre Library, Centreville Regional Library, Franconia Governmental Center, Great Falls Library, Herndon-Fortnightly Library, Lorton Community Center, Mason Governmental Center, McLean Governmental Center, Providence Community Center, Sully Governmental Center, Thomas Jefferson Library, Tysons-Pimmit Regional Library, West Springfield Governmental Center Use the ▲ and ▼ buttons to select the Fahrenheit or Celsius scale.ġ0.Press the SW1 switch to enter the temperature scale into memory. The LED will display the temperature scale.
RINNAI ENERGYSAVER RHFE 263FA N BLINKING 12 CODE
Press the SW1 switch to enter this code into memory.ĩ. If not shown, use the ▲ and ▼ buttons to obtain “F1”.Ĩ. Press the SW1 test button to record the gas type code into memory.

L1: Propane gas at low (sea level) altitude L2: Propane gas unit at high altitudeĪ1: Natural gas at low (sea level) altitude A2: Natural gas unit at high altitudeħ. Select the correct code on the LED display using
RINNAI ENERGYSAVER RHFE 263FA N BLINKING 12 PC
With the unit in the Off position, press the SW1 switch at the top of PC board until it beeps.Ħ. Turn on the gas and power supply to the appliance. Parts of the PC board are supplied with 120 volts AC.ĥ. Ensure that the manometer is properly calibrated.ĭo not touch any other areas on the PC board besides the “SW” switches while power is supplied to the appliance. Both ports must be used in order to measure the differential pressure. Remove two test point screws (1/8 NPT tap) with 3/16 Allen wrench and attach the manometer to both test ports. Pull the panel out at the bottom about 4 inches (100 mm) and lift up over clips that hold it in place at the unit’s top.Ĥ.

Remove the 7 screws that hold the front panel and the louver assembly to remove panel from the unit. Hold both ends of the bottom cover (undercover assembly) and pull toward you to remove the cover. Rinnai Corporation RHFE-263FA Conversion Manualġ. No parts need to be replaced for high altitude.įor high altitude installations in Canada, the conversion shall be carried out by a manufacturer’s authorized representative, in accordance with the requirements of the manufacturer, provincial or territorial authorities having jurisdiction and in accordance with the requirements of CAN/CGA-B149.1 or CAN/CGA-B149 installation codes. The input rate can be verified by following the procedure in the National Fuel Gas Code (NFPA54 / ANSI Z223.1, 2006 or latest edition).Ĭonversion of the appliance for operation at high altitudes (> 2000 ft, 610 m) requires the completion of the section, Adjust Gas Pressure Settings, using the high altitude manifold test pressures above. High Altitude - Manifold test pressure (High) High Altitude - Manifold test pressure (Low) It may also be used to alert against unsafe practices. Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury. Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This symbol alerts you to potential hazards that can kill or hurt you and others.
